corel draw 12 problem

[frits_gr]

hello to everyone, I am new here and I want to ask if you can help me with something. After working on a file of corel draw, i usually erase the Temp file (C:\Documents and Settings\user\Local Settings\Temp) because Corel always , on a large file, informs you that temp file is full and can't save (!!!). Yesterday I did that(after saving and close draw), and .. by result I can open not the file neither the autobackup. It says "Error reading file" , can I do anything at all or start all over again?:(
Thanks to all!

[Drazan]

"Temp or output drive may be full."

My experience in this is that the file you were working with is to big for your computer to handle.

Clicky here for official support link (http://support.corel.com/scripts/rightnow.cfg/php.exe/enduser/std_adp.php?p_sid=lB1-QSui&p_lva=&p_faqid=755308&p_created=1079458603&p_sp=cF9zcmNoPTEmcF9ncmlkc29ydD0mcF9yb3dfY250PTEwM iZwX3NlYXJjaF90ZXh0PVRlbXAgb3Igb3V0cHV0IGRyaXZlIG1 heSBiZSBmdWxsJnBfc2VhcmNoX3R5cGU9MyZwX3Byb2RfbHZsM T0xNSZwX3Byb2RfbHZsMj1_YW55fiZwX3NvcnRfYnk9ZGZsdCZ wX3BhZ2U9MQ**&p_li=)

=)
Jade

[Broacher]

Aside from a cleanup/defrag, re-assign to a new TEMP partition... you should also check your 'undo' settings. The default is pretty big--especially if you do a lot of bitmap work.